RGBlink X3 User Manual page 43

Preview Mode
Click the "Preview Mode", and pop-up window as follows:
Click "OK", the system will synchronize the data, and it will finish about 5 seconds later, click "OK",
it will enter the interface as follows:
In preview mode, Default outputs 2.4.6.8 as preview channel and outputs1.3.5.7 as program
channel.
All scene settings are done in PST and display on preview monitor. Users can drag the signal
from the singal list to PST and when the scene setting is finished. Use the virtual T-Bar to switch
the display to PGM.
X3 User Manual
42