RGBlink X3 User Manual page 42

In matrix mode, any operations are unavailable except signal selection, bank selection, alpha
time and black scene setting.
Default source 1 to monitor 1, source 2 to monitor 2, and so on. Select the signal, and drag it to
the source that will set. For example, set signal 9 for source 1, as shown in the figure below:
Note: Click the monitor (the border of the monitor will turn to red), then double click the signal
(the border of the monitor will turn to yellow), the signal will be switched to the monitor.
Source 1 will be switched to signal 2, click source 1, then click "Take" icon , the signal
will be switched to the corresponding monitor. Connect the signal to the corresponding output
after setting.
X3 User Manual
41