RGBlink X3 User Manual page 32

Note
For example, set the top border, bottom border, left border and right border as 100, as shown in
the figure below:
Close monitor: Click the icon
or click the shortcut
Reset monitor: User can reset the monitor by clicking the shortcut
interface.
Swap monitor: User can swap the monitor by clicking the shortcut
interface, as shown in the figure below.
Auto tile: User can enable or disable the auto tile function by clicking the auto tile shortcut
on the right side of the interface. If select auto tile "ON', the layer will automatically snap to the
output grid when move the layer to the position within the threshold value.
Monitor Size and Position Setting: Move the mouse to the lower right brink of the monitor, and
press the left key of the mouse. Move the mouse to the suitable position and release the mouse.
But this method can only adjust the size and location roughly, if an accurate adjustment is
needed, select the monitor, and set the X, Y, width and height in the bottom of the interface.
X3
Top border and bottom border, left border and
right border are changed equivalently. For
example, if set top border as 100, bottom border
will be changed to 100 automatically, and if set
left border as 200, right border will be changed to
200 automatically.
on the top right corner of the monitor to close one monitor,
on the right side of the interface to close all monitors.
User Manual
on the right side of the
on the right side of the
31