RGBlink X3 User Manual page 33

Monitor Size changed equivalently: Select any monitor, for example, select monitor 1, and
adjust the size. Click this monitor, then press button C and don't let go, select the monitor that will
set, the size of the selected monitor will be changed to the same size of monitor 1, as shown in
the figure below:
Rotation: Select the monitor, and set the rotation as 0°, 90°, 180° and 270° in the bottom of the
interface. Click "OK" to confirm. As shown in the figure below:
Right click the monitor can also rotate the monitor, and each output module can only swap one
output.
Output Area Size Setting: Move the mouse to the output area and slide the mouse wheel, the
output area size can be zoom in and out. When zoom out the output area, press the wheel of the
mouse will drag the whole operation area.
Layer Setting
New Layer: In output screen zone of controlling software, press the left mouse key and drag on
the intended output screen to cover the whole current screen. And the below interface will be
displayed. A layer can also be opened by double clicking the left signal source to be shown on the
window.
Adjust Layer: Two ways can change the size and location of the opened layer:
a. Drag the opened layer by mouse. The details are: move the mouse to the brink of the opened
layer, when the mouse shows"<—>", press the left key of the mouse and drag the window to a
suitable size and then release the mouse. Or move the mouse to the lower right of the opened
layer, press the left key of the mouse and drag the window to a suitable size and then release the
mouse. Move the mouse to the opened layer and press the left key of the mouse and move the
X3 User Manual
32