Table of Contents
Advertisement
Command
IP setup commands cont'd
Set verbose mode
N The SMX can send out unsolicited information (such as a notice of a change in input or some other setting). This a verbose (wordy)
relationship between the switcher and a connected device. For a direct RS-232/422 connection, the SMX is set for verbose mode by default.
When the SMX is connected via Ethernet, verbose mode is disabled by default in order to reduce the amount of communication traffic on the
network. To use verbose mode with a switcher connected via Ethernet, you must set this mode to on each time you reconnect to the SMX.
View verbose mode
Reset commands
Reset all device settings
to factory settings
N Excludes IP settings, e.g., IP address, subnet mask, and gateway address. Does not remove file system.
Absolute system reset
N Includes resetting IP address to 192.168.254.254 and subnet mask to 255.255.0.0. Firmware version remains same.
X3&
N
= Verbose mode: 0 = neither verbose mode nor tagged responses enabled; 1 = verbose enabled, no tagged responses (default);
2 = tagged responses enabled, verbose mode disabled; 3 = verbose mode and tagged responses enabled
ASCII command
(host to switcher)
E X3&
}
CV
E
}
CV
E
}
ZXXX
E
}
ZQQQ
Response
Additional description
(switcher to host)
X3&]
Enable or disable verbose mode and/or
Vrb
tagged responses, in which additional
information is given in query response.
X3& ]
]
Clears all ties and presets, audio gain and
Zpx
volume, and resets unit to factory default.
]
Clears all ties and presets, and resets unit
Zpq
to factory default (mode 5 reset).
Advertisement
Table of Contents
