Saving Or Recalling A Plane Preset; Setting The Front Panel Locks (Executive Modes) - Extron electronics SMX System Setup Manual

Saving or recalling a plane preset

Follow step 1 of "Saving or recalling a global preset".
Step 2 – To save a plane preset, press and hold the Preset button (for 2 seconds).
– To recall a plane preset, press and release the Preset button.
N Saving a preset – Preset button flashes red (shown here).
Recalling a preset – Preset button lights red.
C O N T R O L
ENTER PRESET
N At this time all lit presets are global presets, not plane presets.
Step 3 – Press the desired plane button (here plane 0).
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
0
Plane button lights amber.
N At this time all global presets go out and any saved plane presets
light red (here plane preset #7).
Step 4 – (To save) Press and release the desired input button (here plane preset 3).
– (To recall) Press and release the desired lit input button.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Selected button flashes red. Enter button also blinks (red).
N When saving the current plane configuration to a previously saved plane preset,
the existing data is overwriten.
Step 5 – Press the Enter button to save or recall the plane preset.
C O N T R O L
ENTER PRESET
Current configuration is saved to plane preset 3 and all buttons turn off.

Setting the Front Panel Locks (Executive Modes)

The matrix switcher has three levels of front panel security lock.
Lock mode 0 — The front panel is completely unlocked and
all front panel controls are available. Basic and advanced
features are available.
Lock mode 1 (Executive mode) — All changes are locked from
the front panel (except for setting Lock mode 2). Only View
mode is available.
SMX System MultiMatrix Switchers
Also refer to the SMX System MultiMatrix Switchers User's Manual at www.extron.com.
VIEW ESC
I/O PLANE SELECT
INPUTS
OUTPUTS
VIEW ESC
• Front Panel Operation 3-7