Volkswagen Passat 1995 Official Factory Repair Manual page 594

Cylinder head, removing and installing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
Cylinder head, installing
No. 1 Cyl. piston at TDC
13-21
- Locate camshafts using camshaft jig
3268.
- Install cylinder head gasket. Observe
position of locating dowels in cylinder
block (hole 12 and 20,
V15-0817).
- Place cylinder head on engine block.
- Insert cylinder head bolts and hand-
tighten.
- Tighten cylinder head in four stages
in the sequence shown as follows:
1 - Tighten initially with torque wrench:
Stage I = 40 Nm (30 ft lb)
Stage II = 60 Nm (44 ft lb)
2 - Turn further with normal wrench:
1
Stage lIl = / turn (90 )
4
1
Stage IV = / turn (90 )
4
Note:
Loosening cylinder head: Reverse
sequence.
Re-torquing cylinder head after
repairs is not necessary.
Page 16 of 16
15-11
Page
illustration
5/12/2004