Installing - Volkswagen Passat 1995 Official Factory Repair Manual

Cylinder head, disassembling and assembling
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
- Turn inner part of seal puller 2085 out two turns
(approx. 3 mm) from the outer part and lock with
knurled screw.
- Lubricate threaded part of seal puller, install
and, while applying pressure, screw into seal as
far as possible.
- Loosen knurled screw and turn inner part
against camshaft sprocket mounting bolt until
seal is pulled out.
- Clamp flat surfaces of puller in vise.
- Remove seal from puller with pliers.

Installing

- Oil sealing lip.
- Install seal with sleeve from 10-203 and press in
flush with outer surface of cylinder head.
- Install toothed drive belt and adjust tension
Page 13-13 .
Page 15 of 24
15-21
5/12/2004