Volkswagen Passat 1995 Official Factory Repair Manual page 550

Engine, disassembly and assembly
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
- Place guide rail on locating pin. Insert short
securing bolt with locking fluid "D6" and tighten
both bolts to 20 Nm (15 ft lb).
- Place double chain on intermediate shaft. (Note
direction of rotation of double chain
7 , Fig. 1 ).
- Install camshaft sprocket and double chain to
camshaft for cylinders 2, 4 and 6 (short
camshaft) and hand tighten.
- Install camshaft sprocket with wheel sensor for
camshaft position sensor -G40- and double
chain to camshaft for cylinders 1, 3 and 5 and
hand tighten.
Notes:
Make sure that the contact surfaces of the
timing chain and wheel sensor are dry when
installing.
When installing bolts oil contacting surfaces.
- Remove camshaft jig 3268.
- Tighten camshaft sprocket mounting bolts to:
100 Nm (74 ft lb).
Page 43 of 71
13-28
Page 13-
5/12/2004