Volkswagen Passat 1995 Official Factory Repair Manual page 347

Cylinder head removal and installation
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
Cylinder head, installing
Special tools, testers and auxiliary
items
Torque wrench VAG 1332 (40-200
Nm)
Guide pin 3070
Requirements
Engine cold
Pistons NOT at Top Dead Center
(TDC)
Installing
- To align cylinder head, install guide
pins from tool 3070 into holes for
cylinder head bolts 8 and 10
(arrows).
- Install cylinder head gasket.
- Install cylinder head (note centering
pins in cylinder block).
- Install remaining cylinder head bolts
and tighten by hand.
- Remove guide pins from tool 3070,
insert cylinder head bolts 8 and 10,
and tighten by hand.
Page 7 of 9
15-6
5/12/2004