Lonworks Device Management; The Network "Wink" Command - Daikin MicroTech III Sales And Engineering Data Sheet

The following functions are specific to the L
(in this case, the L W
on orks
functions are used for maintenance and testing. A network
management tool such as Echelon's LonMaker
typically used to issue the network commands.

The Network "Wink" Command

A wink command is initiated by the BAS or through the
L W commissioning software. The "wink" identification
on orks
function allows verification of an individual unit controller
network address without having to physically open the unit's
access panels. The Wink command can be used during all
operating and non-operating (ex. Alarm) modes except for the
following conditions:
• Brownout Mode
• Emergency Shutdown
• Defrost process
Upon receiving a wink command from a network management
node, the unit controller exhibits the following identification
sequence (all occur simultaneously):
• Room Sensor LED: flashes ON for 3.0 sec, OFF for 3.0
sec for 15 total seconds, unless an alarm condition exists.
• Fan: The fan turns off for 5 seconds, turns on for 5
seconds, then off again for 5 seconds.
ED 15103-6 • MICROTECH III WSHP UNIT CONTROLLER
W device
on orks
communication module). These
® software is
Offline
When the L W communication module receives a
on orks
network command to go Offline, the unit controller continues to
operate but communication is suspended except for network
management messages.
Online
When the L W communication module receives a
on orks
network command to go Online, network messaging is
restored.
Reset
When the L W communication module receives a
on orks
network command Reset command, it performs the following:
1. Sends a command to the unit controller to perform a
warm reset, maintaining non-volatile memory.
2. Resets the Neuron processor.
56
l W d m
on orks evICe anagemenT
l
www.DaikinApplied.com
W d m
on orks evICe anagemenT