Printer - ALGE-Timing TdC 8000 Manual

2.2. Printer:

When you switch TdC 8000 on it activates the printer automatically. After you selected the program
you can make the following adjustments for the printer:
Print-Mode:
Buffer-Mode:
Printer Off:
o Paper Check
o Changing the Paper:
Version:E-19-03-07
TdC 8000
The printer prints all data. The printer is automatically in this mode, when
you switch the TdC 8000 on.
All data for the printer are stored in the buffer. This mode you use e.g. to
change the paper.
- Printer is in Print-Mode
- Press <PRINT>
- Printer is now in the Buffer-Mode
- Press <PRINT>
- Printer is again in the printing mode. It prints now all data collected
during the buffer mode.
The printer is off and all data for the printer are lost.
- Printer is in Print-Mode
- Press <ALT> and <PRINT> at the same time
- Printer is switched off
- Press <ALT> and <PRINT> at the same time
- Printer is in Print-Mode
- Push cover release button (11).
- Remove the cover.
- Check the paper.
A black strip will become visible on the edge of paper, when the
paper roll is about to run out.
- Push cover release button (11) .
- Remove the cover.
- Remove the rest of the paper from the holder.
- Press the black lever forward and pull the paper out.
- Put the axle into the paper holder.
- Put the now roll on the paper holder.
Page 10
Page 10