ALGE-Timing TdC 8000 Manual page 43

With  and  it is possible to move the times up and down.
-
- Input all start number as before.
- Press <MEMO> to exit the MEMO-menu
Assigning the same time to two or more competitors:
You can assign the same time to two or more competitors, if you only receive one impulse from
a sensor.
Memory: 1
1
- Input the first start number with finish keyboard (15), e.g. start number 55
- Confirm the start number with <INPUT>
- It stores and prints the time and the start number
- The same time is still on the info-display (6)
Memory: 1
1
- Input the start number with the finish keyboard (15), e.g. start number 10
- Confirm the start number with <INPUT> if you have more numbers to assign, or <ENTER>
for the final entry.
- The time and start number disappears, the Memo-memory is empty.
- Press <MEMO> to exit the MEMO-menu
Attention: - You can delete a false time in the memo-mode by pressing <CLEAR> on the
finish keyboard (15).
- You can enter and exit the MEMO-function at any time without danger of losing
any time.
Each Memo-Time is shown with a continues ID-number. This number can help you to find the
time again later.
If you clear a time in the MEMO mode with <CLEAR>, you can find it again when pressing
<INPUT> and enter start number zero.
Memo-times cleared with <CLEAR> are marked with a capital C.
Run-times cleared with <CLEAR> are marked with a small c.
Version: E-19-03-07
TdC 8000
C1 13:05:11.3453 No:
C1 13:05:11.3453 No:
_ Only one time for two competitors
The same time is in the display
_
Page 43
Page 43