Select A Race - ALGE-Timing TdC 8000 Manual

E.g.: If you clear race 1 and 3 it shows the following figures on the info-display (6):
Clear race:
Continue: ENTER
If you press <ENTER> without pressing an <F> key it will not clear the memory.

2.5. Select a Race:

After clearing the memory you have to select the race that you want to use. You can keep a maxi-
mum of four races at the same time in the memory. Each race is completely independent. This
means that for each race you can use the same bib numbers from 1 to 9999 and you can make up
to 256 heats.
Select race:
Continue: ENTER
Two numbers are shown for each race. The first number shows how much memory you have
used, and the second how much memory you have available. For a cleared race it shows zero as
first number.
When "select race" is displayed the cursor will be placed on the previous race. If you want to select
that race again press <ENTER>.
If you want to select a different race you can select with key <F1>, <F2>, <F3>, or <F4>.
The race selected is always marked with an arrow.
Memory was not cleared:
If you select a race that is not cleared it will show the following message in the info-display (6):
Select Heat:
Continue: ENTER
If you select the same heat, you can continue to work in that same heat as you worked before.
If you select the next heat, then a new heat is started.
If you select a new heat:
- All valid run times (or total times) will be stored as memory time
- All other times will be cleared (e.g. start-, finish- ,intermediate time)
Version:E-19-03-07
TdC 8000
8350/ 253 R1< F1
0/ 253 R2
651/7009 R3< F3
943/7009 R4
7012/ 1591 R1< F1
0/ 1591 R2
651/ 7009 R3
943/ 7009 R4
SAME (1)< F1
NEXT (2)
Page 16
F2
F4
F2
F3
F4
(1) means first heat
(2) means second heat
F2
Page 16