Faults Concerning Supply Voltage; Other Faults - Roland R1000 Series Manual
Double sheet detector with integrated fieldbus interface
Hide thumbs
Also See for R1000 Series:
- Manual (156 pages) ,
- Owner's manual (80 pages) ,
- User manual (4 pages)
Table of Contents
Advertisement
Maintenance
9.10
Faults concerning Supply voltage
No.
Cause
176
Operating voltage was below 20 VDC.
177
Voltage at PLC inputs / outputs too low.
If the fault message 177 appears due to a mis-set system configuration ("monitor PLC voltage" though PLC voltage is not
connected), then simultaneously press all 4 operating keys and thus call up the configuration menu directly, and set the
correct values there. Only then the fault conditions are redressed.
9.11
Other faults
No.
Cause
Unknown error or error description is included in a newer
manual.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
144
Manual
Double Sheet Detector R1000-series I20
with integrated fieldbus interface
Remedy
Check power supply.
Check power supply for PLC inputs / outputs
if required switch off PLC voltage monitoring in the
system parameters.
Remedy
• Contact Roland Electronic Service Department.
• Request for newer manual.
B0060191 / Rev. 1.7
Advertisement
Table of Contents
