Error Codes - Elation Artiste Monet User Manual

E R R O R C O D E S
When power is applied, the unit will automatically enter a "Reset/Test" mode. This mode
brings all the internal motors to a home position. If there is an internal problem with one or
more of the motors an error code will flash in the display in the form of "XXer" were as XX
will represent a function number. For example, when the display shows "0Er" it means there
is some type of error with the Pan motor. If there are multiple errors during the start-up
process they will all flash in the display. For example: if the fixtures has errors on Channel
1, 2, and 5 all at the same time, you will see the error message "01Er", "02Er", and "05Er"
flash repeated 5 times.
If an error does occur during the initial start-up procedure the fixture will self-generate a
second reset signal and try to realign all the motors and correct the errors. If the error persists
after a second attempt a third attempt will be made. If after a third attempt all the errors have
not been corrected the fixture will make the following determinations:
3 or More Errors - The fixture cannot function properly with three or more errors therefore
the fixture will place itself in a stand-by mode until subsequent repairs can be made.
Less Than 3 Errors - The fixture has less than 3 errors; therefore, most other functions will
work properly. The fixture will attempt to operate normally until the errors can be correct by
a technician. The errors in question will remain flashing in the display as a reminder of
internal errors.

ERROR CODES

PAN Er
TILT Er
Cyan Color Wheel Er
Magenta Color Wheel Er
Yellow Color Wheel Er
CTO Wheel Er
Color Wheel Er
Focus Wheel Er
Zoom Wheel Er
Iris Er
AllBladeRotation Er
Prism1 Er
Prism2 Er
Prism_Rot1 Er
Prism_Rot1 Er
Animation Er
AnimationRot Er
Error Codes subject to change without notice.
DESCRIPTION
Movement is not located in the default position after the reset.
This message will appear after a fixture reset if the magnetic-indexing circuit
malfunctions (sensor failed, or magnet is missing) or there is a motor failure
(defective motor or a defective motor IC drive on the main PCB). This error may
also be displayed if the head/yoke was blocked during a reset function.
Movement is not located in the default position after the reset. This message will
appear after a fixture reset if the magnetic-indexing circuit malfunctions (sensor
failed, or magnet is missing) or there is a motor failure (defective motor or a
defective motor IC drive on the main PCB).
41