Elation Artiste Monet User Manual page 17

G O B O I N S T A L L A T I O N
10. Locate the tab of the retaining spring. Using a precision pick (or similar tool), carefully press the retaining
spring inward to relieve the tension. Remove the retaining spring and carefully separate the GOBO from the
GOBO Holder. Lastly, remove the flat washer attached to the removed GOBO and attach it to the desired
replacement GOBO. Install the replacement Rotating GOBO following the steps above in reverse order.
CAUTION: TAKE CARE NOT TO SCRATCH GOBO OR GOBO HOLDER!
REPLACING A STATIC GOBO
11.
Rotate the Static GOBO Wheel until the desired GOBO is visible through the OPEN slot in the Rotating
GOBO Wheel. Using a precision pick (or similar tool), carefully press the Static GOBO Holder down slightly
then using your thumb and index finger, gently pull it out and away until it fully clears from the GOBO Wheel.
12. Locate the tab of the retaining spring. Using a
precision pick (or similar tool), carefully press the
retaining spring inward to relieve the tension. Remove
the retaining spring and carefully separate the GOBO
from the GOBO Holder. Lastly, remove the flat washer
attached to the removed GOBO and attach it to the
desired replacement GOBO. Install the replacement
Static GOBO following the steps above in reverse
order.
CAUTION: TAKE CARE NOT TO
SCRATCH GOBO OR GOBO HOLDER!
17