Cisco UCS S3260 Service Manual page 51

Chapter 3 Maintaining the System
Setting Up Booting in UEFI Mode in the Cisco IMC GUI
Use a web browser and the management IP address of the system to log into the Cisco IMC GUI
Step 1
management interface.
Select Compute and then Server 1.
Step 2
Select the BIOS tab.
Step 3
Under BIOS Properties, set Configured Boot Order to UEFI.
Step 4
Click Save Changes.
Step 5
Click Configure Boot Order.
Step 6
Select the Advanced tab.
Step 7
Click Add Local HDD.
Step 8
In the Add Local Disk dialog, enter the information for the 4K sector format drive. Enter a name and
Step 9
specify Slot M.
Click Save Changes.
Step 10
Click Add Virtual Media.
Step 11
In the Add Virtual Media dialog, enter a name for your OS installation virtual media.
Step 12
Click Save Changes.
Step 13
Click Close.
Step 14
Click Launch KVM to open a virtual KVM window for the server node.
Step 15
In the Launch KVM dialog, select Server 1 and click Launch.
Step 16
Activate virtual media. Pull down the Virtual Media menu on the KVM window and select Activate
Step 17
Virtual Devices.
Reboot the server node.
Step 18
Press F6 during the boot to enter the boot device menu.
Step 19
Select UEFI: Cisco vKVM-Mapped vDVD and press Enter.
Step 20
Proceed with the installation of your OS.
Step 21
After the OS installs and the system reboots, your OS is listed as a boot option.
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
Installing or Replacing System Components
3-17