Cisco UCS S3260 Service Manual page 118

Older Migration and Upgrade Procedures
Figure E-3
1 40-Gb QSFP ports (two on each SIOC)
10/100/1000 dedicated management port
2
Reconnect power cables to the system. Wait for approximately five minutes to let the server nodes boot
Step 6
to standby power during the first bootup.
Connect a KVM cable (Cisco PID N20-BKVM) to the KVM connector on either server node at the rear
Step 7
of the system (see
Open the Cisco IMC Configuration Utility:
Step 8
Press and hold the front panel power button for four seconds to boot the system. Watch the screen
a.
for the prompt to press F8.
During bootup, press F8 when prompted to open the Cisco IMC Configuration Utility.
b.
This utility has three windows that you can toggle between by pressing F1 or F2.
The utility prompts you to change the default user password. Set a default user password before
Step 9
continuing.
Set the CMCs in all SIOCs and the BMCs in all server nodes to the factory defaults.
Step 10
The Factory Default check box has two options but you must perform two resets in this order:
Select Chassis Controller Configuration and save your changes. Both CMCs in the SIOCs are set
a.
to the factory default state.
Select Server Controller Configuration and save your changes. The server node is set back to its
b.
factory default state and the server/host reboots.
Note
Note
When prompted, press F8 to enter the Cisco IMC Configuration Utility again.
Step 11
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
E-24
Appendix E
Rear Panel Connectors for Setup
Figure E-3). Connect a USB keyboard and a VGA monitor to the KVM cable.
The BMC reboots after resetting to defaults. Watch for the prompt to press F8 when the server
reboots in the next step.
Set the BMC in the second server node to factory defaults also.
Upgrading to Cisco UCS S3260 System With S3260 M5 Server Nodes
3 KVM console connector on each server node