Cisco UCS S3260 Service Manual page 31

Chapter 2 Installing the System
For IPv6, if you do not know the gateway, you can set it as none by typing :: (two colons).
The preferred DNS server address.
•
For IPv6, you can set this as none by typing :: (two colons).
Optional: Use this utility to make VLAN settings.
Step 4
Save your changes by pressing F10 before switching windows.
Note
Press F1 to go to the second settings window, then continue with the next step.
Step 5
From the second window, you can press F2 to switch back to the first window.
Optional: Set a host name.
Step 6
Optional: Enable dynamic DNS and set a dynamic DNS (DDNS) domain.
Step 7
Optional: The Factory Default check box has two options:
Step 8
Server Controller Configuration: the selected server node is set back to its factory default state and
•
the selected server/host reboots.
Chassis Controller Configuration: Both CMCs in the SIOCs are set to the factory default state.
•
Optional: Set port properties for the 10/100/1000 dedicated management port on the SIOCs if you do not
Step 9
want the port to use the auto-negotiation feature.
Optional: Reset port profiles and the port name.
Step 10
Save your changes by pressing F10 before switching windows.
Note
Press F1 to go to the third settings window, then continue with the next step.
Step 11
From the third window, you can press F2 to switch back to the first window.
Optional: Set the port speed for the SIOC QSFP ports to either 40 Gbps or 4x10 Gbps.
Step 12
"Adapter-1" refers to SIOC 1 and "Adapter-2" refers to SIOC 2, if present.
Note
If you use a 40G-to-10G splitter cable, you must configure the four 10G ports connected to the cable on
Note
the uplink switch side as part of a single static port-channel. It is possible to use less than four ports, if
all used 10G ports are part of the same static port-channel. You must also set "spanning-tree port type
edge trunk" on the port channel to eliminate STP transition time.
Press F5 to refresh the settings you made. You might have to wait about 45 seconds until the new settings
Step 13
appear and the message
in the next step.
Press F10 to save your settings and reboot the server node.
Step 14
Note
If your system is running Cisco IMC 2.0(9) or later, the default setting is Auto, which
automatically adjusts to your network installation.
Network settings configured
If you chose to leave DHCP enabled, the dynamically assigned IP and MAC addresses are
displayed on the console screen during bootup.
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
is displayed before you reboot the server node
Initial System Setup
2-17