Battery Information (Kx-Tpa60 Only) - Panasonic KX-TGP600G Operating Instructions Manual

Hide thumbs Also See for KX-TGP600G:
Table of Contents

Advertisement

Important Information

Battery Information (KX-TPA60 only)

After batteries are fully charged (at 25 °C [77 °F]):
While Talking (Backlight off
While Talking (Backlight on
*1 When the "Talking" setting of "Backlight" is set to "Off". For details, see "Display Option", Page 111.
*2 When the "Talking" setting of "Backlight" is set to "On". For details, see "Display Option", Page 111.
R Operating time may be shorter than listed above depending on usage conditions and ambient
temperature.
R The batteries will drain slowly even while the handset is turned off.
R The handset can receive calls while charging.
R Battery consumption increases when the handset is out of range (if "
R Clean the handset and the charger contacts with a soft, dry cloth once a month. Clean more
often if the unit is subject to grease, dust or high humidity. Otherwise the batteries may not
charge properly.
Low Battery Warning
The batteries need to be charged in the following situations:
R The battery level indicator displays as empty ("
R "Charge Battery" is displayed. In this situation, the handset cannot be operated.
*1 If the low battery warning occurs during a conversation, after 1 minute, the conversation will be
disconnected, and after 1 more minute, the handset will turn off.
Replacing the Batteries
If the battery level indicator displays as empty ("
the batteries have been fully charged, the batteries should be replaced.
Before replacing the batteries, make sure the low battery warning is displayed, then turn off the power to
prevent memory loss. Replace the batteries and charge the new batteries for about 6 hours.
If you replace the batteries before the low battery warning appears, the battery strength icon may display
an incorrect reading. In this case, use the handset as normal with the new batteries installed.
When the low battery warning is displayed, charge the batteries for about 6 hours or insert the fully
charged batteries. The battery strength icon will then display the correct reading. To install the batteries,
see "Battery Installation", Page 95.
Note
R After replacing the batteries, turn on the handset once with the power key (
you don't turn on the power once before charging, the battery indicator will not display correctly.
R Please use AAA Ni-MH 1.2 V, 630 mAh batteries only. (Contact your phone system dealer/service
provider.)
R There is a danger of explosion if the batteries are incorrectly replaced.
12
Operation
*1
, Narrowband Mode)
*2
, Wideband Mode)
While not in use (Standby)
") and the alarm sounds
") after using the phone for a short time, even when
Operating Time
Up to about 11 h
Up to about 8 h
Up to about 200 h
" flashes, turn the handset off).
*1
.
) before charging. If

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents