Panasonic KX-TGP600G Operating Instructions Manual page 21

Status
Color Light pattern
Amber On
Slow Flashing
Quick Flashing
Slow switching
(RedaGreenaAmberaOff)
Quick switching
(RedaGreenaAmberaOff)
Off —
Note
R The indicator flashing patterns are as follows:
– Slow Flashing: 60 times per minute
– Quick Flashing: 240 times per minute
Handset locator button
You can locate a misplaced handset/desk phone by paging it.
If you press the button again, or after 60 seconds have passed, the page to the handset/desk phone
will be stopped.
You can also register the handset/desk phone to the base unit by pressing and holding the button for
about 3 seconds.
For details, see "Handset/desk phone registration using the base unit", Page 100.
Before Operating the Telephones
R The base unit's IP address may conflict with the IP
addresses of other devices on your local network.
Contact your administrator for further information.
R The base unit is obtaining an IP address or is obtaining
configurations. Please wait.
R The base unit is registering with your phone system.
Please wait
R If the STATUS indicator continues flashing, check the
following:
– Network settings may not be correct. Contact your
administrator.
– Many installation issues can be resolved by resetting
all the equipment. First, shut down your modem,
router, hub, base unit, and computer. Then turn the
devices back on one at a time in this order: modem,
router, hub, base unit, computer.
– If you cannot access Internet Web pages using your
computer, check to see if your phone system is having
connection issues in your area.
– For more troubleshooting help, contact your
administrator.
R Unplug the base unit's AC adaptor to reset the unit, then
reconnect the AC adaptor. If the STATUS indicator is still
flashing rapidly, there may be a problem with the base
unit hardware. Contact your phone system dealer/service
provider.
The base unit is in maintenance mode. Turn the base unit
off and then back on again.
The base unit is restarting. Wait a moment.
R The base unit power is off.
R The Ethernet cable is not connected properly. Connect it.
R Your network devices (hub, router, etc.) are turned off.
Check the LEDs for the link status of the devices.
Meaning
21