Panasonic KX-TGP600G Operating Instructions Manual page 67

*1 When connected to a base unit other than the KX-TGP600, the operation is as follows.
KX-TPA60:
/ /[XFER/CLR]
KX-TPA65/KX-TPA68:
/ /[TRANSFER/CLEAR]
Holding a Call
You can put a call on hold by holding the call at your extension.
Holding
To hold the current call
1. KX-TPA60:
/ /[HOLD/MSG]
KX-TPA65:
/ /[HOLD]
KX-TPA68:
/[HOLD]
Note
R If you select a LINE key other than the one for the current call, the call is put on hold or is disconnected
depending on the Automatic Call Hold settings. For details, contact your phone system dealer/service
provider.
To retrieve a call on hold
1. KX-TPA60:
/ /[HOLD/MSG]
KX-TPA65:
/ /[HOLD]
KX-TPA68:
/[HOLD]
To retrieve a call on hold at your line (when connected to the KX-TGP600 only)
1. /[LINE]
2. Press the dial key corresponding to the slowly flashing green LINE indicator, or press [D] or [C] to
select a slowly flashing green LINE indicator. a
Holding in a System Parking Zone (Call Park)
You can use this feature as a transferring feature.
When Call Park is permitted, the "Call Park" item is available in the Function Key list. However, the Call
Park feature number must be set beforehand. Also, depending on your phone system, you may need to
enter a parking zone number to retrieve a parked call. The feature depends on your phone system.
Contact your administrator for further information.
To set
1. KX-TPA60/KX-TPA65:
/[FUNC]/[FUNCTION] a 9 ("Call Park")
KX-TPA68:
Press the Program Key assigned as "Call Park".
To retrieve (Call Park Retrieve)
[In standby mode]
During a Conversation
OK
67