Tool And Tool Magazine Table - Fagor 8065 Error Solving Manual

Er r or s ol vi ng ma nu a l .

TOOL AND TOOL MAGAZINE TABLE

'The tool cannot be loaded into position %1'
DETECTION During the manual loading of a tool from a dialog box or from the magazine list.
Loading the magazine table.
CAUSE The tool does not fit in that magazine position, it is already in the magazine or it is
not defined in the tool table.
SOLUTION Choose a big enough magazine position. Check that the tool is defined in the table.
'The %1 tool cannot be unloaded'
DETECTION While unloading a tool manually from a dialog box or from the magazine list. Loading
the tool table or magazine table.
CAUSE The tool is not in the magazine.
SOLUTION Select a tool that is in the magazine.
'The maneuver cannot be executed. Check that the spindle is empty'
DETECTION When executing a ground tool loading or unloading block.
CAUSE The spindle is not empty or there is a channel in error status.
SOLUTION Unload the tool from the spindle. Check that the status of all the channels is "READY".
'Wrong table type selected'
DETECTION When loading the tool table or magazine table.
CAUSE The file with the data either does not correspond to the table to be loaded or has been
modified externally.
SOLUTION Choose the file corresponding to the table to be loaded.
'The tool does not exist or is already loaded into the magazine'
DETECTION While loading a tool into the magazine with or without maneuver.
CAUSE The tool does not exist or is already in the magazine, in the spindle or in the tool
changer arms (if any).
SOLUTION Define a tool. If it is in the spindle or in the tool changer arms, load it into the magazine.
'Tool %1 cannot be eliminated'
DETECTION When deleting a tool or when loading the tool table.
CAUSE The CNC cannot find the tool.
SOLUTION The tool is missing, therefore, cannot be eliminated. If it occurs when loading the
table, initialize the table with the softkey and load the table again.
'Tool %1 does not exist or is not loaded into the magazine'
DETECTION When unloading a tool from the magazine, when forcing the position of a tool or when
loading the magazine table.
CAUSE The tool does not exist or is not loaded into the magazine.
SOLUTION Define the tool and load it in the magazine.
'Error when renaming the tool'
DETECTION When trying to change the tool name.
CAUSE It cannot create the tool in the database (bd8070.mdb). The data base may be being
used by another application or it may not have write permission.
SOLUTION The data base must have write permission. If the tool data base is being used by
another application, wait for it to be released (freed).
'A tool that is in the spindle, in the magazine or in the changer arms cannot be renamed'
DETECTION When trying to change the tool name.
CAUSE The CNC has tried to change the name of a tool but there is already another tool with
that name in the spindle, magazine or changer arms (if any).
SOLUTION Choose another number or unload a tool to ground.
CNC 8060
CNC 8065
(R : 1709)
EF
·213·