7000-7999 - Fagor 8065 Error Solving Manual

Er r or s ol vi ng ma nu a l .
7001 'Two consecutive T's in cyclic magazine (M6 required)'
DETECTION During execution.
CAUSE The tool magazine is cyclic and two consecutive tools have been programmed without
M06.
SOLUTION In a cyclic tool magazine, M06 must be programmed after each tool.
7002 'The tool is not in the magazine and ground tools are not allowed'
DETECTION During execution.
CAUSE A tool has been programmed that is in the tool table, but it is not in the magazine table.
In this case the CNC assumes that the tool is a ground tool, but the machine
parameters indicate that ground tools are not allowed.
SOLUTION Configure the machine to accept ground tools or include the tool in the magazine
table.
7003 'T not defined in the table'
DETECTION During execution.
CAUSE The programmed tool is not defined in tool table.
SOLUTION All the tools must be defined in the tool table, even the ground tools.
7004 'Tool rejected or worn out (expired)'
DETECTION During execution.
CAUSE The programmed tool is expired (worn out) or has been rejected by the PLC.
SOLUTION Repair the tool or use an equivalent tool.
7005 'Tool rejected or expired and without replacement'
DETECTION During execution.
CAUSE The programmed tool is expired or it has been rejected by the PLC and there are no
more tools of the same family in the magazine.
SOLUTION Repair the tool or enable a tool of the same family that can be used.
7006 'D not allowed for this tool'
DETECTION During execution.
CAUSE Wrong tool offset. The tool has fewer offsets than the one programmed.
SOLUTION Program an existing offset or add new ones to the tool.
7007 'In load mode: T0 not admitted'
DETECTION During execution.
CAUSE Magazine in load mode. T0 cannot be programmed.
SOLUTION Program the tool to be loaded into the magazine.
7008 'In load mode: This tool is already loaded'
DETECTION During execution.
CAUSE Magazine in load mode. The programmed tool is already in the magazine.
SOLUTION Program a tool that is not loaded yet.
7009 'In load mode: M6 without T'
DETECTION During execution.
CAUSE Magazine in load mode. An M6 cannot be programmed without a tool.
SOLUTION Program the tool to be loaded and then the M06 function.
7010 'In load mode: T with two M6'
DETECTION During execution.
CAUSE Magazine in load mode. Two consecutive M6 have been programmed without a tool.
SOLUTION Program the tool to be loaded and then the M06 function.

7000-7999

CNC 8060
CNC 8065
(R : 1709)
EF
·163·