1000-1999 - Fagor 8065 Error Solving Manual

1000
DETECTION
CAUSE
SOLUTION
1004
DETECTION
CAUSE
SOLUTION
1005
DETECTION
CAUSE
SOLUTION
1006
DETECTION
CAUSE
SOLUTION
1007
DETECTION
CAUSE
SOLUTION
1008
DETECTION
CAUSE
SOLUTION
1009
DETECTION
CAUSE
SOLUTION
CNC 8060
1010
CNC 8065
DETECTION
CAUSE
SOLUTION
(R : 1709)
EF
1011
DETECTION
CAUSE
SOLUTION
·18·

1000-1999

'The function of instruction requires programming the axes'
During execution.
The axes affected by the programmed instruction or G function have not been
programmed.
Check the program.
'Zero spindle speed'
During execution.
The speed of the spindle used with function G63 is zero.
Program a spindle speed.
'Motion block with zero feed'
During execution.
No feedrate is active in the channel.
Program the feedrate F.
'G20: spindle not allowed'
During execution.
Function G20 does not allow programming the spindle.
Check the program.
'The programmed function requires a nonexistent main axis'
During execution.
The programmed function needs one or two main axes and they are missing in the
channel.
Check the program. Following functions G11, G12, G13 and G14 require one of the
two axes of the main plane. Functions G2, G3, G8, G9, G30, G36, G37, G38, G39,
G73 require both axes of the main plane. Both axes of the main plane are also needed
to activate collision detection (#CD) and for function G20 when collision detection is
active.
'Coordinates out of range'
During execution.
The possible causes are:
• The coordinate programmed for the axis is too large.
• Function G101 tries to include an offset too large in the axis.
Check the program.
'G4: the dwell has been programmed twice, directly and using K'
During execution.
The dwell has been programmed twice in the G4 function and in the same block,
directly with a number and with parameter K.
Program the dwell function G4 only once.
'Program G4 K'
During execution.
The dwell time has not been programmed in function G4.
Program G4 as G4 <time> or G4K<time>, where <time> is the dwell time in seconds.
In both cases, the dwell must be programmed after G4.
'G4: dwell out of range'
During execution.
The dwell time programmed in function G4 is too long.
The maximum value allowed for the dwell is 2147483646.
E r r o r so l v i n g m a n u a l .