9000-9999 - Fagor 8065 Error Solving Manual

9301
DETECTION
CAUSE
SOLUTION
9302
DETECTION
CAUSE
SOLUTION
9303
DETECTION
CAUSE
SOLUTION
9304
DETECTION
CAUSE
SOLUTION
9305
DETECTION
CAUSE
SOLUTION
9306
DETECTION
CAUSE
SOLUTION
9307
DETECTION
CAUSE
SOLUTION
CNC 8060
9308
CNC 8065
DETECTION
CAUSE
SOLUTION
(R : 1709)
EF
·202·

9000-9999

'The REFFEED1 and REFFEED2 values of the master and slave axes must be the same'
During the validation of the machine parameters.
There is a gantry or tandem pair whose master and slave axes have different homing
feedrates in a set (parameters REFFEED1 and REFFEED2).
Check the machine parameters. The fast and slow home search speeds (parameters
REFFEED1 and REFFEED2) must be the same for both axes.
'Restart Windows to assume the new value'
During the validation of the machine parameters.
Some change in the machine parameters requires restarting Windows to be effective.
Restart Windows.
'The probe must be associated with a Fagor digital node input.
During the validation of the machine parameters.
Parameter PRBDI1 or PRBDI2 refers to an invalid digital input. Only the digital inputs
that belong to Fagor modules or the logic inputs used only to simulate the probe are
valid.
Assign a digital input of a Fagor module or a logic input to parameters PRBDI1 and
PRBDI2.
'Gantry axes: Both SERCOS axes must have the same OPMODEP'
During the validation of the machine parameters.
There is a gantry o tandem pair whose master and slave axes have parameter
OPMODEP set differently.
Check the machine parameters. Both axes must have the OPMODEP parameter set
the same way.
'It is recommended to decrease the filter order'
During the validation of the machine parameters.
The order number of one of the low passing filters of the axis is too high for the defined
frequency and it could cause overshooting.
Check the machine parameters. Decrease the filter order or increase the frequency.
'FAST filter incompatible with 3rd axis-filter'
During the validation of the machine parameters.
The CNC cannot activate the automatic filter of the HSC FAST because there are
already three frequency filters active on the axis.
Remove a frequency filter of the axis or remove the filter of the HSC FAST mode.
'With Motion Control software option, "CHTYPE" must be a PLC type channel'
During the validation of the machine parameters.
It is an MC model and some channel is not defined as PLC channel.
Check the machine parameters. At the MC model, all the channels must be PLC
channels (parameter CHTYPE).
'Compensation positions out of the module range are not allowed'
During the validation of the machine parameters.
The leadscrew or cross compensation table of the axis has positions that are defined
beyond the limits of the module.
Define all the positions within the module limits.
E r r o r so l v i n g m a n u a l .