8000-8999 - Fagor 8065 Error Solving Manual

Er r or s ol vi ng ma nu a l .
8000 'The simulation kernel is not active'
DETECTION During system startup.
CAUSE The simulation kernel has been started up but is not activated'
SOLUTION Verify that the CNC has started up correctly. Turn the CNC off and back on. If the error
persists, contact the Service Department.
8001 'The simulation kernel is not active'
DETECTION During system startup.
CAUSE The simulation kernel has been started up but is not activated'
SOLUTION Verify that the CNC has started up correctly.
8002 'Error when registering a key'
DETECTION During system startup.
CAUSE The CNC has not been able to register one of the softkeys or one of the hotkeys (quick
access keys)
SOLUTION Verify that the CNC has started up correctly.
8003 'It is not possible to shut it down while it is in execution or interrupted'
DETECTION During execution.
CAUSE The CNC cannot be shut down if it is in execution, interrupted or has an axis occupied
in motion control.
SOLUTION Stop the programs that are in execution.
8004 'It is not possible to shut it down while it is in execution or interrupted'
DETECTION During execution.
CAUSE The CNC cannot be shut down if a channel is in execution, interrupted or has an axis
occupied in motion control.
SOLUTION Stop the programs that are in execution.
8005 'It is not possible to change modes while a channel of the group is in execution'
DETECTION During execution.
CAUSE It is not possible to change modes while a channel of the group is in execution.
SOLUTION Interrupt the programs in execution of all the channels of the group.
8006 'Error while initiating the loading process'
DETECTION During system startup.
CAUSE Error when preparing to load the COMPCI or the remote modules.
SOLUTION Verify that the COMPCI is recognized, check the value of parameter CANMODE and
the installation of the communications driver.
8007 'Error while loading the program from the COMPCI'
DETECTION During system startup.
CAUSE Error when loading the COMPCI.
SOLUTION Verify that the COMPCI has been properly recognized and installed. Contact our
technical service department.
8008 'Error while saving the system configuration'
DETECTION During system startup.
CAUSE Error in the CAN configuration in the loading process.
SOLUTION From Diagnosis mode, check the CAN configuration and compare it with the real one
to determine whether there is a problem when detecting nodes or not.

8000-8999

CNC 8060
CNC 8065
(R : 1709)
EF
·167·