Tool Calibration - Fagor CNC 8065elite T Manual

P r o b i n g ( · T · m o d e l ) .
4.2

Tool calibration.

This cycle may be used to calibrate the dimensions of a tool or a touch probe. Once the cycle
has concluded, it updates the dimensions in the tool table and initializes the tool wears to
0 (zero).
The calibration is done using a tabletop probe.
Requirements prior to the calibration.
If it is the first time the tool or the probe is being calibrated, enter in the tool table an
approximate dimensions, location code and the radius value. If it is a probe, the "R" value
will correspond to the radius of the probe ball and the location code will depend on how it
has been calibrated.
F1
X+
F3
X+
F5
X+
F7
X+
Geometrical configuration of "Plane" type
axes.
Z+
Z+
Z+
Z+
Geometrical configuration of "trihedron"
type axes.
F7
Z+
X+
F5
Z+
X+
F3
Z+
X+
F1
Z+
X+
4.
CNCelite
8058 8060
8065
R . 2106
EF
ꞏ65ꞏ