Parmco OX-1-6S-5 Installation And Operating Instructions Manual page 25

Electrical connec on
Warning!
All electrical work must be
carried out by a suitably
qualified and authorized
electrician. No altera ons
or willful changes in the
electricity supply should be
carried out.
●Before a emp ng the connec on, check whether the voltage indicated on the
ra ng plate corresponds to the actual mains voltage.
●Mains lead should be minimum 1.5m long.
●Earthing wire should be installed in such manner to be the last one pulled out in
case the safety relief device of the mains lead should fail.
●Mains lead behind the oven must be placed in such manner to avoid touching the
back panel of the oven because of the heat it develops during opera on.
●The cable of correct size ra ng must be used cable type H05VV-F 3×1.5mm
grounding wire shall be longer than the other wires.
Connec on (by authorised electrician)
●Using the screwdriver open the connector cover at the rear of the appliance.
Release two locks located at either side of the connector bo om.
●Mains lead must be led through the relief safety device, protec ng the mains lead
cable from disconnec on.
●Tighten the relief device securely and close the connector cover.
Colour code
L=exterior live wires, usually coloured black, brown.
N=neutral
The colour is usually blue.
Beware of the correct N-connec on!
E=earthing wire, the colour is green/yellow.
220-240V 50 Hz
24
2
.the