Inserting a scene from a VCR
– Insert Editing
(1) Set the POWER switch to VCR on your
camcorder.
(2) On the connected VCR, locate just before the
insert start point [a], then press
X to set the VCR to the playback pause.
(3) On your camcorder, locate the insert end
point [c]. Then press X to set your camcorder
to the playback pause.
(4) Press ZERO SET MEMORY on the Remote
Commander. The ZERO SET MEMORY
indicator flashes and the end point of the
insert is stored in memory. The tape counter
shows "0:00:00."
(5) On your camcorder, locate the insert start
point [b] by pressing m, then press z REC
and the button on its right simultaneously.
(6) First press X on the VCR, and after a few
seconds press X on your camcorder to start
inserting the new scene.
Inserting automatically stops near the zero
point on the tape counter. Your camcorder
automatically returns to the recording pause.
4
ZERO SET
MEMORY
To change the insert end point
Press ZERO SET MEMORY again after step 5 to
erase the ZERO SET MEMORY indicator and
begin from step 3.
Using the Remote Commander
In step 5, press z REC and MARK
simultaneously, then immediately press X. In
step 6, press X at the scene where you want to
start recording from.
(1)
(2)
(3)
(4)
(5)
(6)
0:00:00
ZERO SET
MEMORY
[a]
[c]
X
m
X
5
REC
X
X
[b]
z
X
z
X
133