Sony Handycam DCR-TRV40E Operating Instructions Manual page 138

Audio dubbing
Adding audio on a recorded
tape
Choose a connection described on the previous
pages, and connect audio equipment or
microphone to your camcorder. Then follow the
procedure below.
(1) Insert the recorded tape into your camcorder.
(2) Set the POWER switch to VCR on your
camcorder.
(3) Locate the recording start point by pressing
N. Then press X at the point where you
want to start recording to set your camcorder
to the playback pause.
(4) Press AUDIO DUB on the Remote
Commander. The green
appears on screen.
(5) Press X and start playing back the audio you
want to record at the same time.
The new sound is recorded in stereo 2 (ST2)
during playback. While audio is being
recorded, the red
(6) Press x at the point where you want to stop
recording.
To add audio more precisely
Press ZERO SET MEMORY on the Remote
Commander at the point where you want to stop
recording later in the playback.
Carry out from steps 3 to 5. Recording
automatically stops at the point where ZERO SET
MEMORY was pressed.
138
X indicator
appears on the screen.
AUDIO DUB
(1)
(2)
(3)
(4)
(5)
(6)
X
N
X
X
X