Dubbing only desired scenes
– Digital program editing (on
tapes)
When the VCR does not operate correctly
•After checking the code in "About IR SETUP
codes", set the IR SETUP or the PAUSEMODE
again.
•Place your camcorder at least 30 cm (12 in.)
away from the VCR.
•Refer to the operating instructions of your VCR.
Step 2: Setting the VCR to operate
with the i.LINK cable (DV
connecting cable)
When you connect using the i.LINK cable (DV
connecting cable) (optional), follow the
procedure below.
(1) Set the POWER switch to VCR on your
camcorder.
(2) Turn the power of the connected VCR on,
then set the input selector to DV input. When
you connect a digital video camera recorder,
set its power switch to VCR/VTR.
(3) Press MENU, then turn the SEL/PUSH EXEC
dial to select VIDEO EDIT in
the dial (p. 261).
(4) Turn the SEL/PUSH EXEC dial to select
TAPE, then press the dial.
(5) Turn the SEL/PUSH EXEC dial to select EDIT
SET, then press the dial.
(6) Turn the SEL/PUSH EXEC dial to select
CONTROL, then press the dial.
(7) Turn the SEL/PUSH EXEC dial to select
i.LINK, then press the dial.
120
(1)
(2)
, then press
(3)
(4)
(5)
(6)
(7)
2