Firebox Glass Assembly - HEAT GLO PRIMO48 Installation Manual

Hide thumbs Also See for PRIMO48:
Table of Contents

Advertisement

G. Firebox Glass Assembly
WARNING! Risk of Asphyxiation! Handle firebox glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
CAUTION! Risk of Cuts! Wear protective gloves and
safety glasses during installation. Use suction cups to
handle firebox glass.
Note: If a granite surround is installed, the two side
pieces need to be removed in order to access the firebox
glass. See appliance installation manual.
• PRIMO60 AND PRIMO72 MODELS: It is recom-
mended that glass installation and removal be per-
formed by two qualified service technicians.
Removing Firebox Glass Assembly
1. Remove the transition media from the appliance. Lift
the transition media tray out of appliance. The tran-
sition media tray fits tightly, lift carefully. See Figure
11.4.
2. Locate the glass clips that are on the upper edge of
the glass frame of the appliance. See Figure 11.4.
3. Use both index fingers to release the glass clips.
4. Allow glass to tilt forward. Lift up and out. The glass
will lift out of the bottom retaining lip.
Replacing Firebox Glass Assembly
1. Locate retaining lip on lower front face of firebox.
Note: Remove any media that may have fallen into the
glass retaining lip.
2. Place glass assembly into retaining lip. Tilt top of
glass assembly toward fireplace.
3. Assure proper left to right placement of glass and en-
gage all four spring latches.
Firebox Glass Weights
PRIMO48
20.2 lbs
WARNING! Handle glass with care. Glass is breakable.
Inspect the gasket to ensure it is undamaged and inspect
the glass for cracks, chips or scratches.
• Avoid striking, scratching or slamming glass
• Avoid abrasive cleaners
• DO NOT clean glass while it is hot
• Replace as a complete assembly.
• Prepare a work area large enough to accommodate
firebox glass assembly and barrier glass by placing a
drop cloth on a flat, stable surface.
Note: Firebox glass assembly and gasketing may have
residue that can stain carpeting or floor surfaces.
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Installation Manual • 2310-970 Rev. Z • 3/19
64
64
64
PRIMO60
PRIMO72
24.5 lbs
28.5 lbs
Figure 11.4 Location of Glass Clips and Transition Media Tray
GLASS CLIPS
TRANSITION MEDIA TRAY
TRANSITION MEDIA TRAY
ROCK LEDGE

Advertisement

Table of Contents
loading

This manual is also suitable for:

Primo48stPrimo60Primo60stPrimo72Primo72st

Table of Contents