Table of Contents
Advertisement
B. Clean Face Finish (Black Glass Interior)
PRIMO48-CF
PRIMO48ST-CF
PRIMO60-CF
PRIMO60ST-CF
PRIMO72-CF
PRIMO72ST-CF
The PRIMO appliance can be finished with 1/2 inch
sheetrock. Non-combustible finishing is not required.
Preparation
1. Install 1/2 inch sheetrock on wall. Figure 10.3 shows
the PRIMO installed. Sheetrock (1/2 inch) has been
installed up to the top, bottom and sides of appliance
opening as shown in Figure 10.2 and 10.3. See Section
10.A for more details regarding facing material.
Heat Management System Requirements
Additional finishing is required when the Passive Heat Kit
(PHSI-PRIMO, PHFR-PRIMO-48 or PHFR-PRIMO-60)
is selected. The required trim kit (PHTRIM-PRIMO-48 or
PHTRIM-PRIMO-60) must be installed. Reference the in-
structions with the kit for finishing details.
1/2 INCH SHEETROCK WALL
Figure 10.3
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Installation Manual • 2310-970 Rev. Z • 3/19
52
52
52
2. Install sheetrock trim strips as shown in Figure 10.4 on
all sides of appliance. Sheetrock trim strips are included
with the appliance. Cut the strips to the required length
and Install them using staples. See Figure 10.4 for
placement of trim strips.
SHEETROCK TRIM STRIPS
(INSTALLED ON ALL 4 SIDES)
INCORRECT
Installed UNDER painted stop
Figure 10.4. Install Sheetrock Trim Strips
3. Apply the sheetrock mud. When applying the mud,
feather it evenly around the opening throughout the zone
shown in Figure 10.5. A smooth, even surface, covering
a wide area of the wall is desired for best results. For
best results, follow the tips below.
To Reduce the Risk of Sheetrock Cracking:
Use all purpose joint
compound.
Use eggshell paint
(gloss or semi-gloss).
Tape over trim strips.
To Avoid Sheetrock Cracking:
Use a quick set or light weight joint compound.
Use flat paint.
SHEETROCK
TRIM STRIPS
(INSTALLED
ON ALL 4
SIDES)
CORRECT
Installed OVER painted stop
DO
DO NOT
Advertisement
Table of Contents
