Table of Contents
Advertisement
11
Appliance Setup
A. Remove the Shipping Materials
Remove shipping materials from inside or underneath
the firebox. Verify all components are with the fireplace.
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
C. Burner Glass Installation
Installation
1. Locate packaged burner glass pieces shipped inside
the firebox.
2. Position the burner glass tight to the burner tube as
shown in Figure 11.1.
Note: The burner glass is designed to fit tightly. The
screws located adjacent to the burner glass locations may
be loosened in order to allow for more clearance when
placing the burner glass into the appliance.
Note: The two small pieces should be located at the right
end of the burner tube.
3. Slide both rows of glass tight to the screw heads located
in front of the pilot assembly.
NOTICE: Gaps between pieces of glass or between glass
and burner tubes will negatively affect flame appearance.
PILOT ASSEMBLY
*
=LARGE BURNER GLASS PIECES - QUANTITY PER UNIT
PRIMO48/PRIMO48ST = 6
PRIMO60/PRIMO60ST = 8
PRIMO72/PRIMO72ST = 10
Figure 11.1 Burner Glass Installation
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Installation Manual • 2310-970 Rev. Z • 3/19
LARGE BURNER GLASS PIECES*
SMALL BURNER GLASS PIECES (2)
LOCATED OPPOSITE OF PILOT ASSEMBLY
BURNER
61
Advertisement
Table of Contents
