Table of Contents
Advertisement
D. Install Modern Log Set
An optional log set is available for use with the PRIMO
models. Install the log set per instructions included with
kit.
E. Install Media
A media kit is available for use with the PRIMO models.
Install rock media according to instructions included with
media kit.
F. Barrier Glass
WARNING! Risk of Injury! Handle barrier glass with
care. Inspect the glass for cracks, chips or scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
CAUTION! Risk of Injury! Glass installation and removal
must be performed by a qualified service technician. See
chart below for barrier glass weights.
• PRIMO60 AND PRIMO72 MODELS: It is recom-
mended that glass installation and removal be per-
formed by two qualified service technicians.
CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation. Sheet metal
edges are sharp.
Barrier Glass Weights
PRIMO48
12 lbs
WARNING! Risk of Injury! Glass is heavy. Use suction
cups to handle glass.
Remove Barrier Glass - Clean Face Finish
1. Press glass suction cups firmly against glass to create
a solid hold.
2. Slide glass straight up behind finishing material. See
Figure 11.2.
3. Tilt bottom out as shown in Figure 11.2. Slide glass
down to remove it from the appliance.
4. Set glass on prepared work surface.
Heat & Glo • PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST Installation Manual • 2310-970 Rev. Z • 3/19
62
62
62
PRIMO60
PRIMO72
14 lbs
18 lbs
Replacing Barrier Glass - Clean Face Finish
1. Press glass suction cups firmly against glass to create
a solid hold.
2. Tilt glass and slide glass between finishing material
and barrier glass tabs. See Figure 11.3.
3. Center the barrier glass left to right.
4. Tilt bottom in toward appliance. Set glass down into
position on rubber bumpers.
NOTE: When barrier glass is installed, a vertical gap is
formed between the bottom of the glass and the transition
media tray. This required gap allows adequate air flow
through the appliance. The size of the gap is determined
by the PowerFlow™ Heat Management system installed.
WARNING! Risk of Fire! Vertical gap required for proper
airflow. Required gap size depends on PowerFlow™
Heat Management system installed.
• HEAT-OUT-PRIMO/HEAT-ZONE-PRIMO = 3/8 INCH
• PASSIVE HEAT = 5/8 INCH
NOTE:
Barrier glass must be installed between the
finishing material and the barrier glass tabs.
installed correctly, appliance will not operate as intended.
See Figure 11.3.
WARNING!
Risk of Fire!
instructed. Overheating will occur.
Figure 11.2 Barrier Glass - Clean Face Finish
If not
Install barrier glass as
UP
TILT OUT
Advertisement
Table of Contents
