Status Led; Contact Switch (Optional); Anti-Hijack Button (Optional); Pinout Table - Gemini 953N User's And Installer's Manual

18.0 - ACCESSORIES

18.1 - STATUS LED

Since the LED warning light serves as both a system status indicator and a
visual deterrent it must be installed where it can readily be seen.
Always check the rear clearance before drilling:
• Drill a ø 10mm hole and insert the LED holder.
• Gently press the LED holder until it clicks into place.
• Connect the LED Black 2-pin connector to the alarm Black 2-pin connector.
• Bundle up and tie down any excess wires.

18.3 - ANTI-HIJACK BUTTON (OPTIONAL)

Connect the anti-hijack button to the White-Violet wire. The anti-hijack will
trigger when a negative signal is detected.

19.0 - PINOUT TABLE

! ATTENTION
This alarm system is intended for 12V turn indicators.
Before you do any electrical work, make
12V signal.
PAGE 19
sure the flashers are powered by a
CAUTION
Alarms are supplied without wiring harnesses. A wide range of specific pin-
to-pin wiring harnesses is available for the most common motorbikes.
The following tables refer to the generic wiring harness
Pos. Wire color
- 1 - ---
Brown
- 2 -
White-Violet
- 3 -
Green-Brown
- 4 -
---
- 5 -
---
- 6 -
- 7 -
Yellow
- 8 -
Black
---
- 9 -
Grey
- 10 -
White
- 11 -
White-Grey
- 12 -
Orange
- 13 -
Red
- 14 -
Orange
- 15 -
Black
- 16 -
IMMOBILIZER - wire joint
Wire color
Attach to cut end of key switch wire
White
Grey Attach to cut end of main wiring harness.
IMMOBILIZER - grounded wire
Wire color
Connect to a permanent negative connection
White
(do not connect to vehicle chassis
Connect to the cable end which, if grounded, will kill
White/Grey
KITCA 417N17.
Wire function
N/A
Power supply earth ground
LEARN button / Anti-hijack
Contact switch input
N/A
N/A
Ignition
LED negative output
N/A
Immobilizer (N.C.)
Immobilizer (Com.)
Immobilizer (N.O.)
Turn indicators (12V, 6A max.)
Positive supply
Turn indicators (12V, 6A max.)
Antenna
Connections
.
Connections
).
the engine.
PAGE 20