Attaching The Microphone (Sold Separately); Attaching The Video Light (Sold Separately) - JVC Connected Cam GY-HC900CHU Instructions Manual

Attaching the Microphone (Sold
Separately)
You can attach a separately sold microphone to the
microphone holder.
The microphone that is sold separately uses a
phantom power supply.
.
1 Turn the knob on the microphone holder
counterclockwise to loosen and open the
microphone holder.
2 Place the microphone in the microphone
holder.
3 Turn the knob on the microphone holder
clockwise to secure the microphone.
4 Connect the microphone cable to the [MIC
IN] terminal.
5 Pin the microphone cable to the clamp.
6 Perform the settings for the phantom mic
correctly.
(A P69 [Audio Recording] )
1, 3
2
4
Attaching the Video Light (Sold
Separately)
Video lights or accessories can be attached to the
accessory shoe of this camera recorder.
The accessory shoe is of the 1/4-inch screw type.
To make use of a slide shoe, attach the supplied
cold shoe unit.
Attaching the Cold Shoe Unit
1 Remove the plate from the cold shoe unit.
While lifting the catch, slide the plate out.
.
2 Attach the cold shoe unit to the shoe of this
camera recorder using the four screws
supplied.
3 Attach the plate to the cold shoe unit.
Push the catch up from the bottom and slot the
plate into the guide in the direction of the arrow.
.
Attaching the Video Light
The [LIGHT] terminal (D-tap) of this camera
recorder can be connected with a video light (DC
12 V, maximum power consumption 50 W u
w x and DC 12V, 2A v).
Connect the [LIGHT] terminal after attaching the
accessory shoe.
When the [LIGHT] switch is set to "AUTO", the light
goes on only during recording in tandem with the
camera. When it is set to "MANUAL", the light goes
on or turns off respectively when the video light
power is turned on or off.
Settings and Adjustments Before Use
Plate
Catch
Plate
Guide
31