Power Supply; Using Ac Power (Dc In Power) - JVC Connected Cam GY-HC900CHU Instructions Manual

Power Supply

To use this camera recorder, you can attach a
battery pack or connect an AC adapter to it.
(A P34 [Using a Battery Pack] )
(A P33 [Using AC Power (DC IN Power)] )
Caution :
Set the [POWER ON/OFF] switch to "OFF"
0
before changing the power supply that operates
this camera recorder.
Use the camera recorder and peripheral
0
equipments within the rated output of the AC
adapter.
To connect other peripheral equipment, do so
0
under the following conditions.
Keep the total power consumption of the
0
peripheral equipments under 35 W when
using the recommended battery.
Keep the total power consumption of the
0
peripheral equipments under 65 W when
using Tandem 150 (recommended AC
adapter). u w
Keep the total power consumption of the
0
peripheral equipments under 50 W when
using AC-100 (recommended AC adapter).
x
The power consumption of the [LIGHT] terminal
0
is below 50 W. Keep the total power
consumption of the peripheral equipments
excluding the [LIGHT] terminal under 35 W
when using the terminal. If the total power
consumption of the peripheral equipments
exceeds the rating, the power to the [LIGHT],
[DC OUT] (rear) and [DC OUT] (LAN) terminals
is automatically cut off. This is not a malfunction.
Use peripheral equipments with lower power
consumption then turn on the power of this
camera recorder again. u w x
To check the power consumption, refer to the
0
Power screen of the Status screen.
(A P171 [Power Screen] )
If the voltage of the [DC INPUT] becomes 12 V
0
or less, the USB adapter connected to the
[HOST] terminal cannot be used. Check the
power supply and the peripheral equipments,
and turn on the power of this camera recorder
again.
Use a power supply of 12 V/ 2A or below for the
0
[LIGHT] terminal.
The [LIGHT] terminal, DC OUT terminal
(rear)/DC OUT (LAN) terminal and the D-tap
terminal of the battery loading folder cannot be
used at the same time. v

Using AC Power (DC IN Power)

Use the AC adapter (sold separately) to operate
the camera recorder with AC power.
Recommended AC Adapter
u w : Tandem 150 (Anton/Bauer)
: IA-300a (IDX)
v
: AC-100 (IDX)
x
Memo :
For the type of AC adapter to be attached on a
0
battery mount, check the method of attachment
in [Using a Battery Pack] (A P 34).
o Attaching Core Filter Beforehand v
Attach the core filter (large) to the DC cable of the
AC adapter before using the AC adapter.
Release the
5 cm
stopper.
To be connected to the AC Adapter.
.
1 Connect the DC cable of the AC adapter to
the [DC INPUT] terminal of the camera
recorder.
Check that the power of this unit and that of the
AC adapter are both set to "OFF", followed by
connecting according to the diagram.
.
2 Turn on the power of the AC adapter,
followed by setting the [POWER ON/OFF]
switch of this unit to "ON".
Power will be supplied to the camera recorder.
Caution :
Do not insert or remove the DC cable during
0
recording.
Do not use power supply of high voltage
0
fluctuation, containing noise such as ripple, or
with insufficient capacity.
Wind twice
33
Power Supply