JVC Connected Cam GY-HC900CHU Instructions Manual page 79

1 Input the external synchronizing signal to
the external time code generator and the
[GENLOCK] terminal of this camera
recorder.
Memo :
BB signals or HDTV tri-level synchronizing
0
signals are used as the external synchronizing
signal.
If the power of the camera recorder is turned on/
0
off during input of external synchronizing
signals, the screen may appear disrupted for a
few seconds. This is not a malfunction.
2 Input the SMPTE/EBU LTC time code from
the external time code generator to the [TC
IN] terminal of this camera recorder.
Connecting multiple devices, with one as the
master unit and the others as slave units
Master Device
TC OUT
VIDEO OUT
.
1 Connect the [TC OUT] terminal of the
master device with the [TC IN] terminal of
the slave device.
2 Connect the [VIDEO OUT] terminal of the
master device with the [GENLOCK]
terminal of the slave device.
Slave Device
TC IN
GENLOCK
Synchronizing the Time Code with an External Time Code Generator
Settings and Operation of the Camera
Recorder
1 Set to Camera mode.
(A P20 [Operation Modes] )
2 Set [A/V Set] B [Video Set] B [Genlock
Input] to "GENLOCK".
(A P134 [ Genlock Input ] )
3 Set the [TC GEN] switch to "F-RUN".
4 Set LCD monitor or viewfinder to Display
screen.
5 Set the external time code generator or the
master device, and run the time code.
When the built-in time code generator is
0
synchronized with the external time code
data input, the Z icon on Display screen lights
up.
When time code is not synchronized or time
0
code input is not available, the Z icon goes
out.
282min SDI IN
100min
1080 /30p
50min
COMPRESS
ITU709
1 /64
ND AE ±
0
1 / 60
F2.8
.
Memo :
The built-in time code generator will continue
0
operation even when the master device is
disconnected after synchronization.
User's bit will become data in the master device.
0
00: 00: 00.00
5 . 6f t
12 :34 :56
K
ISO B 5600
102400
79