JVC Connected Cam GY-HC900CHU Instructions Manual page 114

Expanded Focus
For configuring the behavior when operating the
user button that is assigned with the "Expanded
Focus" function.
Limited Time:
0
Activates the timer.
Turns off the "Expanded Focus" function about
3 seconds after the user button assigned with
"Expanded Focus" is pressed.
Momentary:
0
The "Expanded Focus" function is enabled
during the interval while the user button
assigned with "Expanded Focus" is pressed.
Toggle:
0
Pressing the user button assigned with
"Expanded Focus" each time switches the
"Expanded Focus" function to on or off.
[Setting Values: Limited Time, Momentary,
RToggle]
Memo :
When "Toggle" is selected after assigning the
0
expanded focus to any of the [J/9], [K/10], [H/
11], [I/12] buttons, press the [CANCEL/
RESET] button if you want to disable the
function.
Video Signal Monitor
For configuring the behavior when operating the
user button that is assigned with the "Video Signal
Monitor" function.
Switch in Order:
0
Pressing the button each time switches the
mode in the following sequence: Vectorscope,
Waveform, Histogram 2, Off.
On/Off:
0
Switches the function configured in [LCD/VF] B
[Shooting Assist] B [Video Signal Monitor] to on
or off.
[Setting Values: RSwitch in Order, On/Off]
114
Camera Function Menu
Return Video
For configuring the behavior when operating the
user button that is assigned with the "Return
Video" function.
CameraGPiP:
0
Pressing the user button assigned with the
"Return Video" function each time toggles
between the captured video and picture-in-
picture return video.
CameraRPiP:
0
The picture-in-picture return video is displayed
when the user button assigned with the "Return
Video" function is pressed and held down, and
the captured video is displayed when the button
is released.
PiPRCamera:
0
The captured video is displayed when the user
button assigned with the "Return Video" function
is pressed and held down, and the picture-in-
picture return video is displayed when the button
is released.
PiPRReturn:
0
The return video is displayed when the user
button assigned with the "Return Video" function
is pressed and held down, and the picture-in-
picture return video is displayed when the button
is released.
CameraRReturn:
0
The return video is displayed when the user
button assigned with the "Return Video" function
is pressed and held down, and the captured
video is displayed when the button is released.
[Setting Values: CameraGPiP, CameraRPiP,
PiPRCamera, PiPRReturn, RCameraRReturn]