JVC Connected Cam GY-HC900CHU Instructions Manual page 75

Hide thumbs Also See for Connected Cam GY-HC900CHU:
Table of Contents

Advertisement

2 Select the framing mode for the time code
generator (only when the frame rate setting
is "60" or "30").
To configure the setting, go to [TC/UB] B [Drop
Frame].
(A P124 [ Drop Frame ] )
[Drop]:
0
Sets the run mode of the time code generator
to drop frame mode. Use this setting when
placing emphasis on the recording time.
[Non Drop]:
0
Sets the run mode of the time code generator
to non-drop frame mode. Use this setting
when placing emphasis on the number of
frames.
Memo :
Drop frame/non-drop frame mode
When [System] B [Record Set] B [Record
0
Format] B [Frame Rate] is set to "60p", "60i", or
"30p", the actual number of frames per second
is approximately 59.94 (29.97). However, the
time code processing standard is "60p", "60i", or
"30p" frames. To make up for the frame number
discrepancy, the drop frame mode (Drop) drops
the 00 frame and 01 frame every minute except
for minutes that are multiples of 10. However, in
the case of "60p", the 00, 01, 02 and 03 frame
are dropped.
The non-drop frame mode (Non Drop) does not
0
drop frames and ignores the discrepancy with
the actual time.
Setting Time Code
1 Select [TC/UB] B [TC Preset] and press the
Set button (R).
(A P124 [ TC Preset ] )
The [TC Preset] screen appears.
TC/UB
00:00:00:00
TC Preset
.
Memo :
When the [TC GEN] switch is set to "REGEN",
0
the parameter is displayed as "REGEN" and
selection is disabled.
2 Set the time code (hour, minute, second,
frame).
Use the cross-shaped button (HI) to place the
cursor at the item to set, then use the cross-
shaped button (JK) to change the values.
TC/UB
00:00:00:00
TC Preset
During drop frame
.
Memo :
Press the [USER3] button to reset each digit to
0
"0". The cursor moves to the time digit (left).
3 Check the values and press the Set button
(R).
The time code is set and the screen returns
0
to [TC/UB].
To cancel the setting, press the [CANCEL/
0
RESET] button.
4 Press the [MENU/THUMB] button.
Returns to the normal screen.
Setting Time Code Generator
1
Cursor
During non-drop
frame
75

Advertisement

Table of Contents
loading

Table of Contents