Table of Contents
Advertisement
Operation
Carry A Load
1.
Carry the load as low as possible while maintaining good
ground clearance and visibility.
2.
Back away slowly.
3.
To travel with a load, use first gear (1) for highest torque
and pulling power. NEVER travel in higher gears when
carrying a load.
Place A Load
1.
Before placing the load, refer to the appropriate load
capacity chart to determine safe boom extension range.
2.
Set the Parking Brake switch to ON (engaged).
3.
Use the frame sway control to level the Telehandler.
For additional information, refer to the Frame Leveling
section in this manual.
Use of the frame sway control with the boom
raised above horizontal could cause tip over
resulting in death or injury. Always use the
frame sway control to level the Telehandler
BEFORE raising the boom above horizontal.
If the Telehandler cannot be leveled using the frame sway
control, do not attempt to raise or place load. Reposition
Telehandler or have the surface leveled.
4.
Align the forks at the level the load is to be placed.
5.
Extend the boom slowly until the load is just above the
area where it is to be placed.
6.
Lower the boom until the pallet rests in position and the
forks are free to retract.
7.
Retract the forks slowly from under the load.
Exercise caution when moving objects con-
taining liquids, as the load may shift during
lifting and handling.
Warning
Warning
Load Shift
1.
If the load shifts, stop the Telehandler immediately.
2.
Lower and adjust the load to center its weight.
3.
If the load shift is too great for adjustment, rearrange the
load before attempting to move the Telehandler.
Elevating Personnel
Use only a compliant work platform to lift or lower personnel.
Never drive the Telehandler with the work platform in a
raised position or with personnel on board, even for a short
distance. Doing so could result in death, serious injury, or
property damage.
Please refer to ANSI/ITSDF B56.6 for additional design and
operating information regarding elevating personnel.
Design Requirements For A Personnel Platform:
1.
Platform floor must have a slip resistant surface located
not more than 8" above the normal load supporting
surface of the fork.
2.
Platform floor dimensions shall not exceed two times the
load center distance. This floor dimension is measured
parallel to the longitudinal center pane of the Telehandler.
3.
Platform floor width shall not be greater than the overall
width of the Telehandler, measured across the load
bearing tires, plus 10" on each side.
4.
Minimum space requirements for each person on the
platform shall not be less than 18" in either direction.
5.
Minimum 4" height toe plate around the perimeter of the
platform which may be omitted at the access opening.
6.
On the overhead protection device, when requested by
the user.
7.
Protection must be provided for the personnel in their
normal working position on the platform from moving
parts of the rough terrain Telehandler that represent a
hazard.
65
Warning
Operation Manual
Hide quick links:
Advertisement
Table of Contents
