Table of Contents
Advertisement
Fork Positioning Carriage Operation
Do not adjust forks when the carriage is loaded. Adjusting
forks when carriage is loaded may result in loss of load or
carriage damage. Always use Fork Positioning (Aux Control)
buttons to adjust the forks BEFORE loading the carriage.
To move the forks outward, press the Aux Control top button
(1) on the front of the joystick. To move the forks inward, press
the lower button (2) on the front of the joystick.
Figure 74. Auxiliary Control Buttons
is rated to be equal or greater than 3,500 psi, which is the
maximum pressure of the Telehandler auxiliary hydraulic
system at the quick-disconnect couplers, could result in
death or serious injury.
When the Attachment Tilt Control
Thumbstick is moved, it activates
hydraulic pressure through the
quick attach couplers (A) and (B)
to move the carriage.
Figure 75. Quick Attach Couplers For
Hydraulic Systems.
(A) Female Coupler. (B) Male Coupler.
Operation Manual
Caution
1
CONTROL
BOOM
FORK TILT
RETRACT
DOWN
SWAY
LEFT
2
FORK TILT
UP
CONTROL
Warning
Hydraulic attachments have a
maximum hydraulic pressure
rating. Failure to make sure the
attachment is equipped with
a pressure reducing valve, or
Quick Attach System
This Telehandler includes a quick attach system that allows for
easy attachment changes. Perform attachment connection
and removal procedures on level ground.
Attachment Connection
AUX
could result in death or serious injury.
BOOM
EXTEND
•
Make sure attachment locking devices are always in
place.
SWAY
•
DO NOT operate the Telehandler until you have positive
RIGHT
indication that the carriage attachment is fully engaged.
AUX
1.
Position the Telehandler directly behind the attachment.
NOTE: Allow enough distance to extend the boom ap-
proximately 18 to 20 inches.
2.
Tilt the quick attach adapter forward.
3.
Extend the boom and/or drive the Telehandler forward
until the pivot pins (A) are below and between the two (2)
attachment hooks (B).
Figure 76. Drive Telehandler Forward to Align Pivot Pins (A) with Attach-
ment Hooks (B)
4. Raise the boom until pivot pins (A) have seated fully in at-
tachment hooks (B).
60
Warning
Improper
connection
attachment can result in death or serious
injury. Attachments not locked into place could
become unstable and fall on the operator or
other personnel near the Telehandler, which
JOYSTICK
ENABLE
B
A
Operation
of
an
auxiliary
18408-001
Hide quick links:
Advertisement
Table of Contents
