Installing - Siemens SIMATIC ET 200SP Manual

12.2

Installing

Requirement
● The PROFINET cables are not inserted on the BusAdapter. The inserted PROFINET
cables hamper the mounting of the strain relief.
● BusAdapter and strain relief can be mounted separately.
Tools required
Screwdriver TX10 (torx).
Procedure
To install the strain relief, follow these steps:
1. Press the strain relief below the BusAdapter seat of the PROFINET device.
Figure 12-2
2. Fasten the strain relief (1 screw with 0.7 to 0.8 Nm tightening torque).
3. Plug the BusAdapter into the PROFINET device.
BusAdapter
Manual, 03/2018, A5E41449003-AA
Strain relief before mounting
Strain relief
12.2 Installing
65