Siemens SIMATIC ET 200SP Manual page 17

BusAdapter BA 2xRJ45
4.2 Connecting
Pin assignment
The following table shows the signal name and description of the pin assignment of
BusAdapter BA 2×RJ45.
Table 4- 1
Procedure
Watch video sequence "Connect BusAdapter BA 2xRJ45 to the ET 200SP interface module"
(https://support.industry.siemens.com/cs/ww/de/view/95886218)
To connect PROFINET IO to the PROFINET device via the BusAdapter BA 2xRJ45, follow
these steps:
1. Plug the BusAdapter BA 2×RJ45 into the PROFINET device.
2. Screw the BusAdapter BA 2×RJ45 to the PROFINET device (1 screw with 0.2 Nm
tightening torque).
3. Plug the RJ45 bus connector into the PROFINET port on the BusAdapter BA 2×RJ45.
You can also swap steps 2 and 3.
16
PROFINET IO pin assignment with BusAdapter BA 2×RJ45
View
1
2
3
4
5
6
7
8
Signal name
TD Transmit Data +
TD_N Transmit Data –
RD Receive Data +
TERM1 Termination Network 1
TERM1 Termination Network 1
RD_N Receive Data –
TERM2 Termination Network 2
TERM2 Termination Network 1
Description
BusAdapter
Manual, 03/2018, A5E41449003-AA