Siemens SIMATIC ET 200SP Manual page 44

Procedure
To connect PROFINET IO to the PROFINET device via the BusAdapter BA SCRJ/FC, follow
these steps:
1. Plug the BusAdapter BA SCRJ/FC into the PROFINET device.
2. Screw the BusAdapter BA SCRJ/FC to the PROFINET device (1 screw with 0.2 Nm
tightening torque). To do this, use a screwdriver with a 3 to 3.5 mm blade, alternatively
TX10.
3. Plug the RJ45 bus connector into the PROFINET port on the BusAdapter BA SCRJ/FC.
BA SCRJ/FC BusAdapter mounted
①
②
③
Figure 8-2
Note
Installation guidelines for modules with PROFINET IO interfaces
Ensure that all devices are connected to the SELV/PELV power supply (or equivalent). Only
then are you permitted to operate the modules with PROFINET IO interfaces in LAN
networks (Local Area Networks).
A data transfer point that guarantees this degree of safety is prescribed for connection to the
WAN (Wide Area Network).
BusAdapter
Manual, 03/2018, A5E41449003-AA
Interface module
BusAdapter BA SCRJ/FC
PROFINET connecting cable
BusAdapter BA SCRJ/FC installed (using an ET 200SP interface module as an example)
BusAdapter BA SCRJ/FC
8.2 Connecting
43