Digistar SCALE LINK SL2 Technical Manual page 60

CAL (D.A.N. 8712) CALIBRATION NUMBER
Weight displayed at 0.4mV/V for these loadcells.
SAVMEN (D.A.N. 8713) SAVE CURRENT RESTORE IMAGE
Saves the current and restore settings to XML files on the USB
LD MEN (D.A.N. 8714) LOAD CURRENT RESTORE IMAGE
Loads any of the restore images from USB and saves those settings in memory
ST SET (D.A.N. 8715) SAVE SETTINGS TO RESTORE IMAGE
Stores current settings into 1 of restore point images. (USER, OEM, FACTORY)
SW SET (D.A.N. 8716) RESTORE SETTINGS TO RESTORE POINT
Restores a restore point to current settings. (USER, OEM, FACTORY)
SYSDTF (D.A.N. 8719) SYSTEM DATE FORMAT
This option will use the system date format when printing stored records (via serial). When this option is disabled, all
stored records printed serially will use a (Date format 7 – DD/MO/YY). If this option is enabled, all stored records will
use the system date format as set in (DATE F – D.A.N 1203). By default, this will be disabled
L POOL (D.A.N. 8732) LOAD DISPLAY POOL
Load a display pool from the USB device into internal memory
D POOL (D.A.N. 8733) DISPLAY POOL STATUS
Show/Display pool status in internal memory
S FACT (D.A.N. 8734) SAVE RAW FACTOR TO USB
Saves a raw ISOBUS 4kb factor from internal memory (serial flash) onto a USB device
L FACT (D.A.N. 8735) LOAD RAW FACTOR FROM USB
Load a raw ISOBUS 4kb factor from the USB device into internal memory
ISOUSE (D.A.N. 8743) VIEW ISOBUS UTILIZATION
View ISOBUS CAN traffic usage as a percent (between 0-100%)
ISO VT (D.A.N. 8745) ISOBUS VT ENABLE
Allows the scales user interface to display on a Virtual Terminal.
Default value for Scale Link ISOBUS scales is ON.
Note: Disabling the Virtual Terminal communications does not affect the settings for ISO WT (D.A.N. 2701) when
broadcasting weight values to ISOBUS.
ISONAM (D.A.N. 8746) ISOBUS NAME
Allows selection of the device name. SL1 or SL2 (For use in ISOBUS applications)
APPSND (D.A.N. 8747) APPLICATION SEND
Allows sending of application specific information (For use in ISOBUS applications)
60 Scale Link 2 Technical Manual D4204-EN