Controls And Indicators; Controls; Indicators - BD Alaris 8002TIG03 Directions For Use Manual

Controls and Indicators

Controls:

Symbol
a
b
h
R
i
d
e
f
g

Indicators:

Symbol
j
S
Description
ON/OFF button - Press once to switch the Pump on . Press and hold down for 3 seconds to switch the
Pump off .
Note: Logs are maintained for power down events including when the pump is powered down or
unexpected power loss .
RUN button - Press to start the infusion . The green LED will flash during infusion .
HOLD button - Press to put the infusion on hold . The amber LED will be lit while on hold .
MUTE button - Press to silence alarm for two minutes . To re-enable the alarm audio press the MUTE
button a second time .
Note: Attention alarm only: when not in alarm press and hold until four audible beeps are heard for
15 minutes silence .
PURGE/BOLUS button - Press to access PURGE or BOLUS soft keys . Press and hold down soft key to
operate .
PURGE - primes the extension set with fluid or drug during initial set up .
• Pump is on hold
• Extension set must not be connected to the patient
• Volume Infused (VI) is not added
BOLUS - fluid or drug delivered at an accelerated rate .
• Pump is infusing
• Extension set should be connected to the patient
• VI is added
OPTION button - Press to access optional features, see 'Basic Features' section .
PRESSURE button - Use this button to display the pumping pressure and alarm level .
This button will also display the pressure trend display .
CHEVRON keys - Double or single for faster/slower increase or decrease of values shown on display .
BLANK SOFTKEYS - Use in conjunction with the prompts shown on the display .
Description
BATTERY indicator - When illuminated the Pump is running on the internal battery . When flashing the
battery power is low with less than 30 minutes of use remaining .
AC POWER indicator - When illuminated the Pump is connected to an AC power supply and the battery
is being charged .
BDDF00001 Issue 5 8/56
Alaris™ Syringe Pumps
Controls and Indicators